HP ProLiant DL360 Generation 4

46 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
5. Remove the battery.
IMPORTANT: Replacing the system board battery resets the system
ROM to its default configuration. After replacing the battery, reconfigure
the system through RBSU.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an
authorized reseller or an authorized service provider.
System Board
1. Power down the server ("Powering Down the Server" on page 16).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
).
3. Remove the access panel ("Removing the Access Panel" on page 18
).
4. Remove the PCI Riser Board Assembly ("PCI Riser Board Assembly" on
page 33
).
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser cage.
5. Remove the processor fan module ("Processor Fan Assembly" on page 29).