HP ProLiant DL360 Generation 4

26 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
3. Remove the optical device.
To replace the drive, slide the drive into the bay until it clicks.
Optical Device Ejector
1. Power down the server ("Powering Down the Server" on page 16).
2. Remove all hard drives ("Hard Drive" on page 21
) and the hard drive blank
(on page 19
).
3. Eject the optical device (on page 25
) or optical device blank (on page 24).
4. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
).
5. Remove the diskette drive ("Diskette Drive" on page 23
).
6. Use a T-10 Torx screwdriver to remove the screws that secure the optical
device ejector to the server chassis.
7. Press the tab on the side of the optical device ejector to release it from the
chassis.