Removal and Replacement Procedures 33
8. Remove the component from the server.
To replace the component, reverse the removal procedure.
PCI Riser Board Assembly
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser cage.
IMPORTANT: Be sure that all DIMM slot latches are closed to provide
adequate clearance before removing the PCI riser board assembly with
a half-length expansion board.
1. Power down the server ("Powering Down the Server" on page 16).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 17
).
3. Remove the access panel ("Removing the Access Panel" on page 18
).
4. Remove the PCI riser board assembly:
a. Disconnect any internal or external cables connected to any existing
expansion boards.
b. Loosen the four PCI riser board assembly thumbscrews.
To Next Page
Loading...
