ProductProduct Minimum firmware versionMinimum firmware version
Server system ROM 1.20
HPE MR type-o and type-p Gen11 controllers 52.22.3-4650
HPE SR900 series type-p Gen11 controllers 03.01.14.062
Installing an energy packInstalling an energy pack
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Remove the air baffle .
To Next Page
Loading...
