Install the server into the rack .
12. Connect all peripheral cables to the server.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server.
16. To configure the M.2 SSD, use the native OS NVMe driver. See the related OS documentation.
ResultsResults
The installation is complete.
Internal USB device optionInternal USB device option
The server has an internal USB 3.2 Gen1 port to install a USB device that can be used as a flash boot media or for data backup/redundancy.
SubtopicsSubtopics
Installing an internal USB deviceInstalling an internal USB device
Installing an internal USB deviceInstalling an internal USB device
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
