6. If installed, remove the air baffle .
7. Based on the SSD form factor (length), verify that the hex nut from the iLO-M.2 serial module option kit is on the correct M.2 standoff
position. Move the hex nut if needed.
8. Install the SSD:
a. Insert the SSD on the iLO-M.2 serial module at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Install the SSD mounting screw.
9. Install the air baffle .
10. Install the access panel .
11. Do one of the following:
Orient the server back to tower mode.
To Next Page
Loading...
