Installing an M.2 SSD on the iLO-M.2-serial moduleInstalling an M.2 SSD on the iLO-M.2-serial module
PrerequisitesPrerequisites
The iLO-M.2 serial module is installed in the server .
Before you perform this procedure, make sure that you have the following items available:
Phillips No. 1 screwdriver
4.5 mm hex nut screwdriver—This tool is required if you need to move the hex nut on the iLO-M.2 serial module to a different M.2
standoff position.
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
To Next Page
Loading...
