12. Power up the server.
13. To configure the memory settings:
a. From the boot screen, press F9F9 to access the UEFI System Utilities.
b. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Memory Options.
ResultsResults
The installation is complete.
iLO-M.2-serial module optioniLO-M.2-serial module option
Install the multifunction iLO-M.2-serial module to support the following:
NVMe SSD in 2280 or 22110 form factors
Serial port
iLO dedicated network port
SubtopicsSubtopics
iLO-M.2-serial module componentsiLO-M.2-serial module components
Installing the iLO-M.2-serial moduleInstalling the iLO-M.2-serial module
iLO-M.2-serial module componentsiLO-M.2-serial module components
ItemItem DescriptionDescription
1 Module stabilizer
2 iLO dedicated network port
3 Serial port cable connector
4 Standoff for the M.2 22110 SSD
5 Standoff for the M.2 2280 SSD
6 Standoff for the M.2 2242 SSD
7 M.2 slot
Not for use in this server
1
1
To Next Page
Loading...
