Documentation
2. (Optional) Install the hardware options.
3. Select the server orientation:
Tower orientation: Connect the peripheral cables and power cord .
Rack orientation: Install the tower-to-rack conversion kit.
4. Decide how to manage the server:
Locally: Use a KVM switch or a connect a keyboard, monitor, and mouse.
Remotely: Connect to the iLO web interface and run a remote console:
a. Verify the following:
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit the HPE website:
https://www.hpe.com/info/ilohttps://www.hpe.com/info/ilo
The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
Note the following:
The iLO hostname is on the serial number/ iLO information label on the top side of the chassis.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are on the serial number/ iLO information label on the top side of the chassis.
c. Enter the iLO login name and password, and then click Log In.
d. In the navigation tree, click the Remote Console & Media link, and then launch a remote console.
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
6. Configure the initial server setup.
7. Set up the storage .
8. Deploy an OS or virtualization software.
9. After the OS is installed, update the drivers.
Setting up the server in tower modeSetting up the server in tower mode
ProcedureProcedure
1. Return the server to an upright position.
2. Connect all peripheral cables to the server.
3. Connect each power cord to the server.
4. Connect each power cord to the power source.
To Next Page
Loading...
