Left and right rack rail assemblies
Server tray
Cable management arm
Chassis rear bracket screws (3)
Rack rail specificationsRack rail specifications
This server supports the HPE tower-to-rack conversion kit (874578-B21). which has the following specifications. This tower-to-rack
conversion kit supports the following specifications:
Type: Ball-bearing (stab-in)
Minimum rail length: 727.50 mm (28.64 in)
Rail adjustability range: 570.00–812.00 mm (22.50–32.00 in)
SubtopicsSubtopics
Installing the tower-to-rack conversion kitInstalling the tower-to-rack conversion kit
These screws are not for use in this server.
Installing the tower-to-rack conversion kitInstalling the tower-to-rack conversion kit
About this taskAbout this task
In this procedure, left and right terminology is from the perspective of a user facing the front of the rack.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
5. Install the rack rails and server tray .
6. Install the server into the rack .
7. Install the cable management arm
ResultsResults
The installation is complete.
SubtopicsSubtopics
Install the rack rails and server trayInstall the rack rails and server tray
Install the server into the rackInstall the server into the rack
Install the cable management armInstall the cable management arm
1
1
To Next Page
Loading...
