20. Connect each power cord to the power source.
21. Power up the server.
ResultsResults
The installation is complete.
Expansion card optionsExpansion card options
The server supports the installation of full-height, full-length, and full-height, half-length PCIe expansion / add-in (AIC) cards such as:
HPE type-p storage controller
Ethernet adapter
Fibre channel host bus adapter (FC HBA)
Accelerator (workload, computational, or graphics accelerator)
For more information on the expansion options validated for this server, see the server QuickSpecs on the Hewlett Packard Enterprise
website:
https://buy.hpe.com/us/en/p/1014788890https://buy.hpe.com/us/en/p/1014788890
SubtopicsSubtopics
Installing an expansion cardInstalling an expansion card
Installing an expansion cardInstalling an expansion card
PrerequisitesPrerequisites
Install the PCIe fan and air baffle .
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either an expansion
slot cover or an expansion card installed.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
