Install the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Wait for 10 minutes for the server to reset and reinitialize the iLO configuration settings stored in SRAM.
IMPORTANT:IMPORTANT: If iLO security is disabled, the configuration will not be restored. To restore the configuration manually,
see https://www.hpe.com/support/ilo6https://www.hpe.com/support/ilo6.
18. Power up the server.
19. Properly dispose of the old battery.
For more information about proper battery disposal, contact an authorized reseller or an authorized service provider.
Safety, warranty, and regulatory informationSafety, warranty, and regulatory information
SubtopicsSubtopics
Regulatory informationRegulatory information
Warranty informationWarranty information
Regulatory informationRegulatory information
To view the regulatory information for your product, view the Safety and Compliance Information for Server, Storage, Power, Networking,
and Rack Products, available at the Hewlett Packard Enterprise Support Center:
https://www.hpe.com/support/Safety-Compliance-EnterpriseProductshttps://www.hpe.com/support/Safety-Compliance-EnterpriseProducts
To Next Page
Loading...
