16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server.
ResultsResults
The installation is complete.
Storage controller optionsStorage controller options
The server supports the following storage controllers:
Intel VROC for HPE Gen11 (Intel VROC)—Provides enterprise-level hybrid RAID support for direct attached SATA SSDs.
HPE Smart Array E208e-p SR Gen10 Controller
HPE MR216i-p Gen11 Controller
For more information on drive array and storage controller configuration, see Configuring storage controllers.
SubtopicsSubtopics
Preparing the server for storage controller installationPreparing the server for storage controller installation
Installing a type-p PCIe plug-in controller optionInstalling a type-p PCIe plug-in controller option
Preparing the server for storage controller installationPreparing the server for storage controller installation
PrerequisitesPrerequisites
Before beginning this procedure, download the Service Pack for ProLiant (SPP) from the Hewlett Packard Enterprise website
(https://www.hpe.com/servers/spp/downloadhttps://www.hpe.com/servers/spp/download).
ProcedureProcedure
1. If the server was previously configured:
a. Back up data on the system .
b. Close all applications.
c. Ensure that users are logged off and that all tasks are completed on the server.
CAUTION:CAUTION: In systems that use external data storage, be sure that the server is the first unit to be powered down and
the last to be powered back up. Taking this precaution ensures that the system does not erroneously mark the drives as
failed when the server is powered up.
2. If the server firmware is not the latest revision, update the firmware.
3. If the new controller is the new boot device, install the controller drivers .
Installing a type-p PCIe plug-in controller optionInstalling a type-p PCIe plug-in controller option
PrerequisitesPrerequisites
To Next Page
Loading...
