Installing the iLO-M.2-serial moduleInstalling the iLO-M.2-serial module
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
Spudger or any small prying tool
Phillips No. 1 screwdriver
T-15 Torx screwdriver
4.775 mm hex screwdriver—This tool is required for installing the serial port cable.
4.5 mm hex nut screwdriver—This tool is required when installing an M.2 SSD.
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
