3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Locate the internal USB port.
9. Plug in the USB device into the USB port.
10. Install the air baffle .
11. Install the access panel .
12. Install the front bezel .
13. Do one of the following:
Orient the server back to tower mode.
To Next Page
Loading...
