Remove a media deviceRemove a media device
About this taskAbout this task
For better access to internal components, some procedures require the removal of the media device.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. Disconnect all cables from the media device:
RDX backup system cabling
Optical drive cabling
8. Pull and hold the device release latch, and then slide the media device out of the bay.
To Next Page
Loading...
