HP ProLiant ML30 Gen11 - Page 93

170 pages

To Next Page

To Previous Page

13. Connect the SATA-power Y-cable to the drive, and then route the cable through the clip on the optical drive cage.

14. Slide the optical drive into the media bay until it clicks into place.

HPE ProLiant ML30 Gen11 Server User Guide 93

Main Page

Component Identification8
Front Panel Components8
Front Panel Leds and Buttons12
Front Panel LED Power Fault Codes14
Rear Panel Components14
Rear Panel Leds16
System Board Components17
System Maintenance Switch Descriptions19
DIMM Slot Numbering20
DIMM Label Identification21
Pcie Expansion Slot Definitions24
Drive Bay Numbering25
Fan Numbering28
Fan Mode Behavior29
Media Device Screws29
Trusted Platform Module30
Setting up the Server35
Setting up the Server in Tower Mode36
Operational Requirements37
Space and Airflow Requirements37
Temperature Requirements38
Power Requirements38
Electrical Grounding Requirements39
Rack Warnings and Cautions39
Server Warnings and Cautions40
Electrostatic Discharge41
Power down the Server42
Extend the Server from the Rack42
Remove the Server from the Rack43
Remove the Front Bezel44
Remove the Access Panel45
Open the Cable Management Arm46
Remove the Air Baffle47
Install the Air Baffle52
Install the Access Panel52
Install the Front Bezel53
Install the Server into the Rack54
Power up the Server58
Hardware Options Installation58
Tower-To-Rack Conversion Kit59
Installing the Tower-To-Rack Conversion Kit60
Install the Rack Rails and Server Tray61
Install the Cable Management Arm68
Drive Options72
Drive Installation Guidelines72
Power Supply Options79
Hot-Plug Power Supply Calculations80
Power Supply Warnings and Cautions80
Redundant Power Supply Enablement Option80
Media Device Options85
Optical Drive Option89
Installing an Optical Drive89
Storage Controller Options98
Minimum Firmware Versions102
Installing an Expansion Card112
Memory Option115
DIMM Population Information115
DIMM Installation Guidelines116
Installing a DIMM116
Internal USB Device Option128
Installing an Internal USB Device128
Cabling Guidelines131
Cabling Diagrams132
Internal Cabling Management134
Storage Controller Cabling134
SFF Hot-Plug Drive Controller Cabling136
Drive Power Cabling137
Storage Controller Backup Power Cabling141
Media Device Cabling141
Optical Drive Cabling143
System Fan Cabling145
Serial Port Cabling147
Front I/O Cabling148
GPU Auxiliary Power Cabling149
Power Supply Cabling149
Configuration Resources151
Updating Firmware or System ROM152
Configuring Security155
Server Management155
NMI Functionality156
Troubleshooting Resources156
System Battery Replacement157
System Battery Information157
Removing and Replacing the System Battery157
Safety, Warranty, and Regulatory Information160
Notices for Eurasian Economic Union161
Turkey Rohs Material Content Declaration162
Warranty Information162
Environmental Specifications162
Mechanical Specifications163
Power Supply Specifications164
Support and Other Resources168
Accessing Hewlett Packard Enterprise Support169
Accessing Updates169
Customer Self Repair170
Remote Support170
Documentation Feedback170

HP ProLiant ML30 Gen11 - Page 93

Table of Contents

Related product manuals