Installing the PTM16
PTM Base Unit Description
The PTM base unit comes factory assembled and contains the following components (see Figure 5).
Figure 5 PTM base unit
Installing a Single PTM Base Unit (5U Models)
To install a single PTM base unit:
1. Install two 5U libraries, as shown in Figure 6, following the instructions in the HP StorageWorks
MSL6000 Series Tape Library User Guide.
NOTE: Each library needs to be pulled out sequentially from the front of the rack enclosure to gain
access to the top PTM cover plate screw on a lower library. See Figure 8 for screw locations.
1 Drive Motor Pulley
2 Drive Belt
3 Belt Block Bracket Access Cutout
4 Media Elevator Car
5 Belt Block and Brackets
6 Thumbscrews (Top, Middle, and Bottom)
7 Belt Tensioner Ramp and Idler Pulley
8 Primary Motor Cable
9 Primary Motor Cable Connector
10 Reserved for future use
11 Printed Circuit Board (PCB), Motor
Controller
12 Drive Motor
7
3
5
8
q
2
w
6
4
1
6
6
-
9
To Next Page
Loading...
