HP StorageWorks MSL6000 series - Updating Firmware Using the Remote Management Interface

Configuring the PTM42
3. Scroll down to Library Flash Operation.
Figure 31 Updating firmware using the Remote Management Interface
4. Select Flash Library from Remote File or Flash Library from Local File (see
Figure 31).
File.
Figure 32 Copying firmware using the Remote Management Interface
NOTE: If you select Flash Library from Local File, the *.bin file must be copied from
ftp://ftp.hp.com/pub/products/storageworks/msl to the /upload directory, which is located on the
library at the IP Address/upload. The level 1 password may be required to perform this procedure.
Figure 33 Confirming the Flash operation using the Remote Management Interface
5. Click Confirm to start the Flash operation. The library firmware automatically updates.