MSL6000 series pass-through mechanism reference guide 29
Figure 20 Installing the timing belt on the extension
Figure 21 Installing the timing belt
CAUTION: To prevent damage to the PTM media elevator car it must be supported from
underneath any time you are performing procedures on the belt block bracket assembly.
7. Place the timing belt ends on the belt block (see Figure 22).
8. Use diagonal cutting pliers to cut the drive belt. If the belt was sized properly, a small space
between the belt ends should be visible.
9. Secure the timing belt with the two belt brackets and four retaining screws.
To Next Page
Loading...
