Installing the PTM18
Figure 7 Accessing drive bay 1
3. Remove the PTM cover plate.
NOTE: If the PTM cover plate has not previously been removed, each library needs to be pulled
out sequentially from the front of the rack enclosure so you can gain access to the top PTM cover
plate screw on a lower library.
a. Using a #1 Phillips screwdriver, remove the screw securing the cover plate to the top of each
library chassis.
b. Using a stubby or right-angle #2 Phillips screwdriver, remove the screws securing the cover
plate to the inside of the drive cage of each library chassis.
c. Using a #2 Phillips screwdriver, remove the screws that secure the PTM cover plate to the rear
of each library chassis (see Figure 8).
NOTE: Do not discard the PTM cover plate or screws. If the unit ever requires shipping, the PTM
cover plate must be reinstalled to prevent in-transit damage.
To Next Page
Loading...
