8. Secure the front of the rail to the front EIA column using the flat securing screw/guide pin (provided in the
package) in the bottom screw position of the rail.
Installing the enclosure
CAUTION:
Install disk drives in the enclosure only after mounting the enclosure in the rack. An enclosure with disk
drives installed is too heavy to lift safely.
Procedure
1. Slide the enclosure into position on the rails (1). Secure the chassis into the rack by tightening the captive
CTO screw (3) behind the latch on the front left and right bezel ears of the chassis (2).
CAUTION:
The front CTO screw must be attached at all times when racked.
Installing the enclosure 27
To Next Page
Loading...
