HP storevirtual 3200 - Network Configuration for Array Enclosure with 10 Gbe;10 Gbase-T Controller Modules (Two Port)

1. Servers 2 . 1 GbE iSCSI SAN
3. Cloud connections 4. StoreVirtual storage system
Network configuration for array enclosure with 10 GbE/10GBase-T controller
modules (two port)
All iSCSI, Remote Copy, and Management traffic are routed through these ports. The ports are bonded
together for redundancy and performance during the Configuration Setup procedure.
Physical requirements
• Connect 10G-1 and 10G-2 on each controller to a switch (four 10 GbE connections)
• The two 1 GbE ports must be disabled
IP addresses required
• Two for the 10 GbE/10GBase-T network on Controller 1
• Two for the 10 GbE/10GBase-T network on Controller 2
• One for the VIP
• All other interfaces are disabled
The following figure illustrates the cabling described.
1
2
3
4
Figure 16: Configuration using four 10 GbE / 10GBase-T ports and two switches
34 Network configuration for array enclosure with 10 GbE/10GBase-T controller modules (two port)