HP storevirtual 3200 - Network Configuration for Array Enclosure with 1 Gbe Controller Modules (Four Port)

SV3200
Servers
1 GbE iSCSI SAN
Figure 14: Configuration using four 1 GbE ports and one switch
Network configuration for array enclosure with 1 GbE controller modules (four
port)
All iSCSI, Remote Copy, and Management traffic are routed through these four ports. The 1 GbE ports are
bonded together for redundancy and performance during the Configuration Setup procedure.
Physical connections
• Connect 1G-1, 1G-2, 1G-3 and 1G-4 on each controller to a switch (eight 1 GbE connections)
Required IP addresses
• Two for the 1 GbE network on Controller 1
• Two for the 1 GbE network on Controller 2
• One for the VIP
• All other interfaces are disabled
The following figure illustrates the cabling described.
Figure 15: Configuration using four 1 GbE ports and two switches
Network configuration for array enclosure with 1 GbE controller modules (four port) 33