1. Servers 2 . 10 GbE/ 10GBase-T iSCSI SAN
3. Cloud connections 4. StoreVirtual storage system
Network configuration for array enclosure with Fibre Channel controller
modules (two port)
The two Fibre Channel ports on each controller are used for data connections, and the two 1 GbE ports can
be used for Management and Remote Copy. The 1 GbE ports are bonded together for redundancy and
performance during the Configuration Setup procedure.
Physical connections
• Connect FC-1 and FC-2 on each controller to a switch (four Fibre Channel connections)
• Connect 1G-1 and 1G-2 on each controller to a switch (four 1 GbE connections)
Required IP addresses
• One for the 1 GbE network on Controller 1
• One for the 1 GbE network on Controller 2
• One for the VIP (Best Practice)
• All other interfaces are disabled
Figure 17: Configuration using four Fibre Channel ports and two switches on page 35 illustrates the
cabling described.
Figure 17: Configuration using four Fibre Channel ports and two switches
1. Servers 2. Fibre Channel SAN
3. StoreVirtual storage system 4. Cloud connections
5. 1 GbE iSCSI SAN
Network configuration for array enclosure with Fibre Channel controller modules (two port) 35
To Next Page
Loading...
