Replacing a power supply module
Verifying power supply failure
Procedure
1. Before replacing a power supply, check the power supply status LED to ensure that the power supply has
failed. For the location of the power supply LEDs, see HPE StoreVirtual 3000 drive enclosure on page
12. For information on interpreting the status, see "Related reference".
Related reference
Status LED descriptions on page 15
Removing a power supply
Procedure
1. Remove the power cable from the power supply to be replaced.
2. Press the latch (1) and slide the power supply module out of the enclosure (2).
60 Replacing a power supply module
To Next Page
Loading...
