HP storevirtual 3200 - iSCSI Multipathing without DSM or MEM

• A total of four or eight IP addresses can be defined depending upon the number of ports.
• A virtual IP address is configured.
• The client must be enabled with multipathing so that it knows that the same disk is accessible from
multiple paths.
• An iSCSI session from each initiator IP to the virtual IP address used by the StoreVirtual storage system
must be created.
iSCSI multipathing without DSM or MEM
• Access the SVMC to configure StoreVirtual networking. See the StoreVirtual Management Console Online
Help for more information.
Each controller has a pair of physical network interfaces that are bonded together.
• Two IP addresses are assigned to the bond for optimal performance.
• A total of four or eight IP addresses can be defined depending upon the number of ports.
• A virtual IP address can be configured.
• The client must be enabled with multipathing so that it knows that the same disk is accessible from
multiple paths.
• An iSCSI session from each initiator IP to each of the four or eight IPs used by the StoreVirtual storage
system must be created.
iSCSI multipathing without DSM or MEM 41