HP storevirtual 3200 - Installing and Verifying I;O Module; Installing an I;O Module; Verifying I;O Module Operation

1
2
3
3. Pull the I/O module (3) out of the enclosure using the I/O module handle.
Installing an I/O module
Procedure
1. Slide the replacement I/O module (1) into the enclosure and close the I/O module handle (2).
2. Tighten the captive retainer thumbscrew (3).
3
2
1
3. Reconnect all cables to the I/O module.
Verifying I/O module operation
Procedure
1. Ensure the I/O module is operating properly by checking the status LEDS. For more information, see
"Related reference".
Related reference
Storage controller enclosure controller module status LEDs on page 17
Installing an I/O module 59