To Next Page

To Previous Page

Battery Maintenance

4-2 HP Uninterruptible Power System T1000 XR and T1500 XR Models User Guide

HP CONFIDENTIAL Codename: Sherman Part Number: 216164-002 Last Saved On: 8/27/02 4:20 PM

Determining When to Replace Batteries

When the Bad Battery/Low Battery LED (1) illuminates red, batteries may need to be

replaced within 30 to 60 days.

Figure 4-1: Bad Battery/Low Battery LED

To check a battery alarm, initiate a UPS battery self-test to verify that battery replacement is

required. If the Bad Battery/Low Battery LED (1) remains red, replace the batteries as soon

as possible.

NOTE: Depending on usage and environmental conditions, the batteries should last three to six years.

For more information on initiating a self-test, refer to the section, “Initiating a Self-Test,” in

Chapter 2.

Obtaining New Batteries

New batteries may be required within 30 to 60 days when the Bad Battery/Low Battery LED

illuminates red. Obtain spare batteries for the UPS when this occurs.

HP supplies spare battery packs for UPS T1000 XR and T1500 XR models. The UPS spare

battery kit part number for the UPS T1000 XR is 240792-001. The UPS spare battery kit part

number for the UPS T1500 XR is 240794-001.

CAUTION: Because of the short shelf life of the battery, avoid storing a battery spare as a

backup. Do not maintain an onsite inventory of spare batteries unless a procedure to keep

stored batteries charged is implemented.

Other manuals for HP T1000 XR

Questions and Answers:

Need help?

Do you have a question about the HP T1000 XR and is the answer not in the manual?

General

Output Power Capacity (Watts)	900 Watts
Topology	Line Interactive
Rack Height	2U
Waveform Type	Sine Wave
Nominal Output Voltage	230V
Nominal Input Voltage	230V
Typical Backup Time at Half Load	15 minutes
Interface Port	USB
Device Type	UPS
Input Voltage	230V
Output Voltage	230V
Frequency	50/60 Hz
Waveform	Sine Wave
Typical Recharge Time	3 hours
Operating Temperature	0 to 40°C
Storage Temperature	-15 to 45°C
Relative Humidity	0 to 95% non-condensing
Output Power Capacity	1000 VA
Input Connection	IEC C14
Battery Type	Sealed Lead Acid
Transfer Time	4 ms
Dimensions	438 x 89 x 482 mm