9. When the HP Management Agent on the client receives the task, the client will display a warning
message indicating that the device will reboot in 15 seconds.
The client will shut down, then start up in DOS mode and run the clone utility which copies the
contents of the flash storage to an .img file on the FTP Repository. The last line on the client display
will indicate progress in percentage completed. Note that this may take several minutes.
10. The client will reboot after cloning has completed and enter Maintenance Mode. DO NOT turn off
the device during this procedure! The client will then reboot again.
11. The Tasks pane in the Management Console will continue to indicate that the task is processing.
The cloned image is being compressed. When the task has finished, a new template will appear
in the Task Templates pane with the name you specified in step 5 (the result template).
12. You can now use this template to apply the cloned image to other devices of the same model type
and identical flash storage size just by dragging and dropping it on the device(s) in the Device Tree.
You can view information about the image associated with the template by double-clicking on the name
of the template to display the Template Editor dialog box. This will display the name of the image and
the FTP Repository where it is stored, its OS build number, original size, compressed size, and
checksum.
Images 139
To Next Page
Loading...
Need help?
General