HP UPS Network Module User Manual

Specifications 73
Item Description
Configuration menu access
control
Password: admin (not modifiable)
Date and time
Synchronize with HP Power Protector
Settings/AUX connector
9600 bits/s, 8 bits, 1 bit stop, no parity
Default parameters
Parameter Default value Possible value
Network
IP address
192.168.1.2 Network IP address
Subnet mask
255.255.0.0 Network IP address
Gateway Address
0.0.0.0 Network IP address
BOOTP/DHCP
Enabled Active / Deactivated
IPv6 Enabled
Enabled Active / Deactivated
IPv6 Auto Config Enabled
Enabled Active / Deactivated
Firmware Upload
Enabled Active / Deactivated
SMTP server
smtpserver 49 characters maximum
System
UPS Contact
Computer Room Manager 49 characters maximum
UPS Location
Computer Room 31 characters maximum
History log interval (sec.)
60 10 to 99999 sec.
Default Language
English English / Japanese
Notified Application table
empty NA
Access control
User name
admin 10 characters maximum
Password
admin 10 characters maximum
SNMP
Community name read
public
32 characters maximum
Trap port
162 Not configurable
SNMP Version
V1&V3 Disabled, V1, V3, V1&V3
Read-Only User
readuser 1 character minimum, 32 characters maximum
Read-Only Security Level
Authentication None, Authentication, Authentication&Privacy
Read-Only Password
readuser 8 characters minimum, 24 characters maximum
Read-Write User
wirteuser 1 character minimum, 32 characters maximum
Read-Write Security Level
Authentication&Privacy None, Authentication, Authentication&Privacy
Read-Write Password
writeuser 8 characters minimum, 24 characters maximum
Date and time
Date and time adjustment
Accept automatic update from
HP Power Protector
Synchronize with an NTP server, Accept
automatic update from HP Power Protector,
Synchronize manually
NTP server
ntpserver 49 characters maximum

HP UPS Network Module Specifications

General

Brand	HP
Model	UPS Network Module
Category	Network Hardware
Language	English