HP XP1024 - Page 37

Installation 37
ODE> run mapper 2
STARTING EXECUTION OF MAPPER2
Processor Identification:
Hardware Model: 5CBH, Revision: 0
Software Model: 4H, Revision: 0
… …
I/O Configuration:
Type HW SW Revisions
Path Component Name ID Model Model Hdwr Firm
---------- ----------------------------------- ----- ----- ----- ----- -----
0 Astro BC Runway Port CH 582H BH 0 0
0/0 Elroy PCI Bridge DH 782H AH 0 0
0/0/0/0 Ethernet Controller 1011H 0019H 103CH 104FH 41H
… …
0/6 Elroy PCI Bridge DH 782H AH 0 0
0/6/2/0 Symbios SCSI Controller 1000H 000FH 103CH 12C0H 37H
0/6/2/0.0.0 HP OPEN-3 - - - - 0118
0/6/2/0.0.1 HP OPEN-3 - - - - 0118
0/6/2/0.0.2 HP OPEN-3 - - - - 0118
0/6/2/0.0.3 HP OPEN-3 - - - - 0118
… …
Resetting the Boot Device...
Done.
Exiting...
RUN COMPLETED.
ODE>
4. For the newly added disk array, the SCSI HBA is at I/O path 0/6/2/0,
and the disk array LUNs are at I/O paths 0/6/2/0.0.0, 0/6/2/0.0.1,
0/6/2/0.0.2, and so on.
5. Exit back to ISL> prompt.
ODE> exit
6. Start the OS on the primary boot path.
ISL> start norecovery group=config
7. Use IOCONFIG to configure the SCSI HBA and SCSI disk Ldevs.
CSYLE18<PUB.SYS>:ioconfig
IOCONFIG A.00.00 (catalog A.00.00) (c) 1994 Hewlett-Packard Co. All Rights Reserved
ioconfig:lpath path=0/6
PATH: *0/6 LDEV:
ID: PAT_PCI_BC TYPE: BC
PMGR: PCI_ELROY_MGR PMGRPRI: 2
LMGR: MAXIOS: 0
ioconfig:lpath path=0/6/2
Warning: Path doesn't exist. (IOCONFIG 37)
ioconfig:
ioconfig:apath path=0/6/2; id=pci_device
ioconfig:apath path=0/6/2/0; id=a5159a
ioconfig:apath path=0/6/2/0.0; id=pseudo
ioconfig:adev ldev=300; path=0/6/2/0.0.0; id=hpdarray
Class(es) updated, so rerun asoctbl.pub.sys to recreate asociate.pub.sys.
BEGIN VOLUME MOUNTING ON LDEV 300 (AVR 9)