Heading Option Description
Storage
Options
Removable Media Boot
Enables/disables ability to boot the system from removable media.
Legacy Diskette Write
Enables/disables ability to write data to legacy media.
BIOS DMA Data Transfers
Enables/disables DMA transfers for IDE and SATA devices when possible during POST to increase
transfer speed.
SATA Controller #0
Enables/disables SATA controller 0.
SATA Controller #1
Enables/disables SATA controller 1.
SATA Controller #2
Enables/disables SATA controller 2.
IDE Controller
Enables/disables IDE controller.
Boot Order Enables you to configure the boot, diskette drive, and hard drive orders by physically reordering
the menu entries. Each device on the list can be individually excluded from or included for
consideration as a bootable operating system source. Boot Order presents these selections:
●
Optical drive
●
Diskette drive
●
USB device
●
Hard drive
●
Network controllers (2)
Boot devices can be disabled from participating in the boot order process. Boot order changes are
stored when the F10 Setup changes are confirmed by selecting File>Save Changes and Exit.
NOTE MS-DOS drive lettering assignments might not apply after a non-MS-DOS
operating system has started.
Shortcut to Temporarily Override Boot Order
To boot one time from a device other than the default device specified in Boot Order, restart the
workstation and press the F9 key when the F9=Boot Menu message appears on the screen. After
POST is completed, a list of bootable devices is displayed. Use the arrow keys to select the
preferred bootable device and press Enter. The workstation then boots from the selected device
for this one time.
Table 3-1 Computer Setup Utility menu descriptions (continued)
28 Chapter 3 System management ENWW
To Next Page
Loading...
