WARNING! Before removing the workstation access panel, be sure that the workstation is
powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system.
2. If a lock is present, unlock the access panel (
Access panel on page 61). The keys are on the rear
panel (
Rear panel components on page 4). Also, unlock any other locks that are present
(Kensington, or Padlock).
3. Pull up on the handle and lift off the cover.
Figure 4-5 Opening the access panel
To replace the access panel, align the bottom groove of the access panel with the bottom edge of the
chassis. Rotate the access panel toward the chassis and press firmly until the latch engages.
Front bezel
To remove the front bezel:
1. Lift up on the three (1) tabs located on the front bezel.
2. Rotate the front bezel away (2) from the chassis, and remove the bezel.
62 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
