Arabic / Greek - Russian /
Czech - Korean / Taiwanese /
Danish - Latin American - Thai /
French ! Norwegian - Turkish .
French
Canadian
é Polish - U.K. English /
German - Portuguese - U.S. English /
* For Bosnia-Herzegovina, Croatia, Slovenia, and Yugoslavia.
Clearing passwords
If you forget your password, you cannot access the workstation. See
Resetting the password jumper
on page 176 for instructions on clearing passwords.
Hood sensor (Smart Cover Sensor)
The optional hood sensor is a combination of hardware and software technology that can alert you when
the workstation side access panel has been removed. There are three levels of protection, as described
in the following table.
Table 3-5 Hood sensor protection levels
Level Setting Description
Level 0 Disabled Hood sensor is disabled (default).
Level 1 Notify User When the workstation is restarted, the screen displays
a message indicating that the workstation side access
panel has been removed.
Level 2 Setup Password When the workstation is restarted, the screen displays
a message indicating that the workstation side access
panel has been removed. You must enter the setup
password to continue.
These settings can be changed using the Computer Setup Utility.
Setting the hood sensor protection level
To set the hood sensor protection level:
1. Power on or restart the workstation.
2. As soon as the screen illuminates, press and hold the F10 key until you enter the Computer Setup
Utility. Press Enter to bypass the title screen, if necessary.
NOTE If you do not press the F10 key at the appropriate time, you must restart the
computer and press and hold the F10 key again to access the utility.
If you are using a PS/2 keyboard, disregard the keyboard error message that might appear.
Table 3-4 National keyboard delimiter characters (continued)
46 Chapter 3 System management ENWW
To Next Page
Loading...
