The Tiger SHARK
™
is supplied with 6 standard cutter wheels.
CW-1011: used for cabinet, padlock, and most vehicle applications
CW-14MC : used for most standard cylinder keys
CW-90MC: similar to the CW-14MC, but makes cuts with a steeper slope for special applications
CW-20FM: 76 degree cutter used for Sargent keys
CW-47MC: 87 degree cutter used for certain automotive keys
CW-1012: for Medeco® keys
Flat Steel cutters, the Emhart cutter (CW-1013), the ASSA Cutter (CW-32MC), as well as others,
are optional cutter wheels that are available for use with the Tiger SHARK
™
.
Refer to the HPC website, www.hpcworld.com for a complete list of cutters and applications.
2.2 Replacing Cutter Wheels
Cutter wheels eventually wear out and become dull. The life expectancy of a cutter wheel
is dependent on the quantity and types of keys you are cutting and the composition of your key
blanks.
HPC does not recommend sharpening cutter wheels. Each time a cutter is sharpened, a
small amount of material is removed and the diameter is slightly reduced. This reduction in diam-
eter will result in cuts shallower then the manufacturer’s specifications.
2.1 Cutter Wheel Descriptions
To Next Page
Loading...