7. Troubleshooting
Problem: The machine does not switch on / power up.
Solution: Check cord at machine inlet and at power outlet.
Check fuse (located in the power inlet on the back of the machine)
Problem: Display on screen is garbled or is all white (no characters shown) .
Solution: Turn machine off. Wait 10 seconds. Turn machine on.
This operation acts as a re-set.
Problem: Buttons do not display expected result, for example selecting “S” displays “X”.
Solution: Calibrate screen (refer to section 5.6). If this does not solve the
problem, switch machine off, then while pressing the bottom left corner
of the screen, switch machine on.
Problem: Cutter motor does not engage / power up.
Solution: Verify shoulder gauge and tip gauge are all the way down.
Verify Decoder Plate is fully seated in the storage compartment.
Problem: Machine is jammed
Solution: Clean work area thoroughly of all key dust and debris.
A hand vacuum or small brush is recommended.
To Next Page
Loading...
