HPC Tiger SHARK - 4.3 Cutting Specialty Keys

26
4.3 Cutting Specialty Keys
1. Medeco
®
Keys
Medeco
®
Biaxial
®
keys use a combination of the depth of the cut, angle, and position of angle for
each chamber of the cylinder. The cutter head on the Tiger SHARK
™
automatically pivots to cut the
appropriate angle.
Medeco
®
Code Position & Angle Tiger SHARK
™
DSD 3076 Buttons
K Fore, Left Depth, then Left
B Fore, Center Depth, then Center
Q Fore, Right Depth, then Right
M Aft, Left Left, then Depth
D Aft, Center Center, then Depth
S Aft, Right Right, then Depth
Medeco
®
uses the following letters to identify the angles and position:
To cut these keys, use the Medeco
®
Biaxial
®
for Tiger
SHARK
™
DSD (No. 3076). For a Fore Cut, enter the
depth of the cut, followed by the angle. For an Aft Cut,
enter the angle followed by the depth.
Because the option exists for cutting double angles, this
DSD number allows 3 positions for each space of the key
(depth, fore, and aft). If you are cutting only single
angles, the Tiger SHARK
™
will automatically fill in a 0
(indicating no cut) in the unused position.
4C 7L 2C 5C 9R 5R
Medeco
®
Angle Cut Keys use DSD
3076 - Medeco
®
Biaxial
4076 - Medeco
®
Biaxial Double Cut
3051 - Medeco
®
Standard
When performing angle cuts the
Tip Stop Gauge must remain up
and use of the Standard Cutter Nut
may be required.
The Tiger SHARK
™
will also accommodate double cuts,
utilizing 2 cuts in each chamber. Consult with Medeco
®
for their specifications on using double-cut angles. To
cut double angles, use DSD 4076. Enter the depth, then
the fore angle, then the aft angle.