Special Best style tip gauging.
3.3 4-Way Jaws
The Tiger SHARK
™
is equipped with state of the art 4-way jaws. These jaws are expertly machined to insure
secure holding of virtually all keys. The 4 sides are marked as follows:
The A-side is for most standard size keys.
The B-side is for most small size keys.
The CUT SCREEN or BITTING SCREEN will indicate which side to use for the particular key to be cut.
The sides marked and are for use with double sided keys. The indicates the holding ridge is on the
bottom jaw, pointing up. The indicates the holding ridge is on the top jaw, pointing down.
These holding ridges will allow you to clamp on the grooves in the keyway. When you use
these sides of the jaw you are not gauging from the back of the jaw, as you do on the A-side
and B-side.
To change sides:
D. Tighten wing nut.C. Swivel to another side.B. Grasp bottom jaw
and lift upwards.
A. Loosen the wing nut.
To Next Page
Loading...
