CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server (Power down the server on page 20).
4. Disconnect all peripheral cables from the server.
5. Remove the system board module from the chassis (Removing the system board module from the
chassis on page 22).
6. Place the module on a flat, level work surface.
7. Install the M.2 SSD on the M.2 riser board.
8. Install the riser board.
9. Install the system board module.
Hardware options installation 49
To Next Page
Loading...
