WARNING: To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed against it. Pay
particular attention to the plug, electrical outlet, and the point where the cord extends from the
server.
Installing the rails and the cable management arm
Installation hardware
In kits supporting 1075 mm racks, the cable management arm and the power cord management brackets are
not included.
Item Hardware (Scale 1:1) Quantity/Tool
A 4 10-32 panhead shoulder screw
T-25 Torx
Only 2 are used when the cable
management arm is installed.
B 2 10-32 slotted screws T-25 Torx
For cable management arm only
C 1 square-hole cage nut
For cable management arm only
Prerequisites for installation
Procedure
1. Observe the following:
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack.
Install the heaviest item first, and continue to populate the rack from the bottom to the top.
Installing the rails and the cable management arm 33
To Next Page
Loading...
