To Next Page

To Previous Page

Installing the mounting rails

WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:

• The leveling feet are extended to the floor.

• The full weight of the rack rests on the leveling feet.

• If it is a single-rack installation, the stabilizing feet are attached to the rack.

• The racks are coupled together in multiple-rack installations.

• Only one component is extended at a time. A rack may become unstable if more than one

component is extended for any reason.

Procedure

1. Extend the brackets to the appropriate length.

2. Insert screws through the rack into the mounting rail and the front and back of each mounting bracket.

Installing the UPS

Before installing the UPS, review and observe all warnings in Precautions.

WARNING: A risk of personal injury or damage to the equipment exists. Uneven loading of equipment in

the rack might cause the rack to become unstable. Install the heavier components first, and then

continue to populate the rack from the bottom to the top.

Procedure

1. Install the mounting rails.

2. With one person on each side of the carton, lift the chassis and lower it to the floor in front of the rack.

3. Install the mounting ears on the chassis using the screws provided.

Installation 15

Other manuals for HPE G2 R5000

Questions and Answers:

Need help?

Do you have a question about the HPE G2 R5000 and is the answer not in the manual?

General