HPE G2 R5000 User Manual

Troubleshooting
Bypass mode
Symptom
LED is on.
Cause
• An overload or a fault has occurred.
• A command has been received and the UPS is in Bypass mode.
Action
1. Equipment is powered but not protected by the UPS.
2. Check one of the following alarms.
• Overtemperature
• Overload
• UPS failure
Battery low
Symptom
LED is on, one beep for every three seconds.
Cause
The UPS is in Battery mode and the battery is running low.
Action
1. The warning is approximate, and the actual time to shutdown may vary significantly.
2. Depending on the UPS load and number of ERMs, the battery low warning might occur before the
batteries reach 20% capacity.
No battery
Symptom
LED is on, continuous beep.
Cause
The batteries are disconnected.
Troubleshooting 31

HPE G2 R5000 Specifications

General

Power Capacity	5000 VA / 4500 W
Input Voltage	200-240 VAC
Output Voltage	200-240 VAC
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 VAC
Nominal Input Voltage	230 VAC
Frequency	50/60 Hz
Form Factor	Rackmount
Interface	USB, Serial
Operating Temperature	0°C to 40°C
Operating Humidity	0 to 95% RH non-condensing
Weight	30 kg