To Next Page

To Previous Page

Main menu Submenu Display information or menu function

Reset average

power

Clears average power usage measurement

Reset cumul.

power

Clears cumulated power usage measurement

Dry contacts test Tests dry contact relay outputs

Settings Local settings Sets product general parameters

In/Out settings Sets output parameters

On/Off settings Sets on/off conditions

Battery settings Sets battery configuration

Event log Event filter Selects faults, alarms, and events to display

Event list Displays the events stored

Reset event list Clears events

Fault log Fault list Displays the faults stored

Reset fault list Clears faults

Identification — Product type, serial number, UPS firmware, communication card IPv6,

communication card MAC, detected accessories

product

— Links to the HPE registration website

Verifying the RPO port connection

NOTE: While testing, operate connected equipment in a safe test mode so the effects do not disrupt critical

operations.

Prerequisites

Connect the RPO port.

Procedure

1. Initiate an RPO by closing the RPO contact.

2. Verify proper connection of the RPO port.

a. Power up the UPS by pressing the Power button.

b. Disconnect the RPO port.

c. Reconnect the RPO port.

d. Verify that the UPS remains in Online mode.

Operations 27

Other manuals for HPE G2 R5000

Questions and Answers:

Need help?

Do you have a question about the HPE G2 R5000 and is the answer not in the manual?

General