HPE G2 R5000 User Manual

Maintenance
Replacing the UPS
Procedure
1. Power down all attached load devices.
2. Power down the UPS.
3. Unplug the UPS power cord.
4. Disconnect all cabling.
5. Remove the screws securing the UPS to the rack.
6. Remove the UPS from the rack.
To replace the component, reverse the removal procedure.
Replacing the ERM
Procedure
1. Disconnect all ERM cabling.
2. Remove the screws securing the ERM to the rack.
3. Remove the ERM from the rack.
To replace the component, reverse the removal procedure.
Updating the UPS firmware
To update the UPS firmware, see the Hewlett Packard Enterprise website.
30 Maintenance

HPE G2 R5000 Specifications

General

Power Capacity	5000 VA / 4500 W
Input Voltage	200-240 VAC
Output Voltage	200-240 VAC
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 VAC
Nominal Input Voltage	230 VAC
Frequency	50/60 Hz
Form Factor	Rackmount
Interface	USB, Serial
Operating Temperature	0°C to 40°C
Operating Humidity	0 to 95% RH non-condensing
Weight	30 kg