HPE G2 R5000 User Manual

UPS does not start
Symptom
The UPS does not power up.
Solution 1
Cause
The input source is not connected correctly.
Action
Check the input connections.
Solution 2
Cause
The RPO switch is active or the RPO connector is missing.
Action
If the UPS status menu displays the "Remote Power Off" notice, inactive the RPO input.
I/O bad wiring
Symptom
I/O LED is on and there is a continuous beep.
Cause
I/O cables are not connected to the correct terminal blocks.
Action
Correctly connect the I/O cables.
34 Troubleshooting

HPE G2 R5000 Specifications

General

Power Capacity	5000 VA / 4500 W
Input Voltage	200-240 VAC
Output Voltage	200-240 VAC
Battery Type	Sealed Lead-Acid (SLA)
Nominal Output Voltage	230 VAC
Nominal Input Voltage	230 VAC
Frequency	50/60 Hz
Form Factor	Rackmount
Interface	USB, Serial
Operating Temperature	0°C to 40°C
Operating Humidity	0 to 95% RH non-condensing
Weight	30 kg