HPE ProLiant DL320 Gen11 - Page 179

2. Power down the server.
3. If installed, open the cable management arm .
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the middle cover .
9. Disconnect the front USB and Display cable from the system board .
10. If you are removing the front USB and Display port Y-cable from the optical drive cage, disconnect the optical drive cable from the
system board.
11. To remove the front USB and DisplayPort Y-cable from the LFF drive chassis:
a. Remove the front USB and DisplayPort assembly.
Retain all screws. These screws will be used to secure the assembly after the front USB and DisplayPort Y-cable replacement.
b. Remove the front USB and DisplayPort Y-cable from the assembly.
Retain all screws. These screws will be used to secure the new front USB and DisplayPort Y-cable.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 179