Removing and replacing an accelerator from the GPU riser cageRemoving and replacing an accelerator from the GPU riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION:CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation
procedure. Improper grounding can cause electrostatic discharge.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the middle cover .
10. Remove the GPU riser cage.
11. Remove the GPU bracket retainer (callouts 1 and 2) and the accelerator (callout 3).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an accelerator from the rear riser cageRemoving and replacing an accelerator from the rear riser cage
To Next Page
Loading...
