To Next PageTo Next Page
Need help?Do you have a question about the HPE ProLiant DX360 Gen10 and is the answer not in the manual?
General| Processor | Intel Xeon Scalable Processors |
|---|---|
| Processor Sockets | 2 |
| Memory Slots | 24 DIMM slots |
| RAID Support | HPE Smart Array controllers |
| Power Supply | 1600W |
| Remote Management | iLO 5 |
| Operating System Support | Windows Server, Linux, VMware |
| Memory | Up to 3TB DDR4 |
Details of front panel ports, buttons, and bays.
Explains status and function of front panel LEDs and buttons.
Describes the function and status of Systems Insight Display LEDs.
Explains system conditions based on combined SID LED status.
Identifies and describes components on the rear panel.
Details the status and function of rear panel LEDs.
Identifies and describes components on the system board.
Explains the status and meaning of hot-plug drive LEDs.
Describes the status and meaning of NVMe SSD LEDs.
Describes methods for powering on the server.
Explains procedures for powering down the server.
Instructions for extending the server from its rack.
Steps to remove the server from the rack.
Specifies clearance and airflow needs for rack installation.
Details acceptable operating temperature ranges.
Electrical and power connection requirements for the server.
Requirements for proper electrical grounding.
Instructions for connecting a DC power cable.
Lists important safety warnings and cautions for server operation.
Safety warnings related to rack installation and stability.
Steps for installing the server into a rack.
Steps to install the OS using Intelligent Provisioning.
Procedure for installing a redundant hot-plug power supply.
Procedure for installing a DIMM into the server.
Procedure for installing an NVDIMM in the server.
Procedure for installing HPE Persistent Memory modules.
Steps to install a hot-plug SAS or SATA drive.
Instructions for installing NVMe drives.
Procedure for installing an expansion board in the primary riser cage.
Steps to install an accelerator or GPU in the primary riser cage.
Procedure for installing an expansion board in the secondary riser cage.
Steps to install an accelerator or GPU in the secondary riser cage.
Procedure for installing the P408i-a SR Gen10 Controller.
Steps to install the P408i-p SR Gen10 Controller.
Procedure for installing the P816i-a SR Gen10 Controller.
Steps to install the P824i-p MR Gen10 controller in a server.
Procedure for installing a processor heatsink assembly.
Steps to install a high-performance heatsink.
Procedure to install and enable the TPM 2.0 Gen10 Kit.
Steps to enable TPM functionality as TPM 2.0.
Steps to enable TPM functionality as TPM 1.2.
Overview of HPE iLO 5 for remote server management.
Tool for server deployment and setup.
How to select between UEFI and Legacy BIOS boot modes.
Tool for configuring arrays on Smart Array SR controllers.
Application for monitoring and maintaining MR controllers.
Methods to update firmware or system ROM.
System software and firmware solution ISO download.
Tool for updating firmware, drivers, and system software.
Utilities for staging, installing, and activating firmware/driver updates.
Procedure to update firmware via System Utilities.
Procedure to update firmware via UEFI Embedded Shell.
Lists available resources for troubleshooting server issues.
Procedure for removing and replacing the system battery.
Details operating and non-operating environmental conditions.
Details on the available power supply units.
Information on how to contact HPE support.
