10. If the card requires rear support, install the GPU support bracket.
11.
Install the primary PCI riser cage on page 35.
12.
Install the access panel (
Install the access panel on page 32).
13.
Install the server in the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server on page 31.
Secondary PCI riser options
Installing a secondary full-height PCI riser cage option
When installed, this riser cage supports full-height, 3/4-length expansion boards up to 95". PCIe3 slot 2 is no longer
available.
Prerequisites
This option requires a dual processor configuration.
90 Hardware options installation
To Next Page
Loading...
